Sailboat

Small Sailboat hull designed for the Make It Float challenge. It is all designed around being able to be printed on a my printrbot simple XL. If printing goes well I might make a remote controlled version.

The Design of the hull is an original design that plays off of design characteristics of many full size sailboats. My design goal was to create a hull that was very printer friendly yet still reminiscent of a real sailboat.

All parts were designed using Sketchup. The hull is designed to be printed with no need for support material if parts are set up like in the print setup file. The Hull pieces are designed to print at 75% or higher infill. The bow and stern pieces can be printed at a lower infill 10% should be more then enough. I am planing on printing soon and will make note if infill needs to be changed. The keel and rudder parts should be printed at 100% infill.

The Hull is designed to be printed by any experience level and the assembly should be also able to be