Slicer Discord
Salt and Pepper Shaker – Modèle 3D imprimable de Thingiverse Thingiverse

Salt and Pepper Shaker

par sonesh
26 Téléchargements
35 Likes
0 Makes
Voir le modèle
Designed a salt and pepper shaker for the dining table.

Shakers (2-3 hours each):
Prints 35mm x 65mm, so you may wish to scale up to your preference.
0.1mm resolution in PLA came out beautifully.
Printing at this resolution does take time, but the mirror shine seen in the pictures is straight off the printer. No sanding/buffing/polishing needed.
Post Print, you'll need to make a hole in the top. I heated a tiny allen key, and popped in through the top. Just needs a little tidying with a knife afterwards.
What I forgot to do was to mirror the 2nd shaker so it would be twisting in the opposite direction. I think this would have looked better.

Stopper (3 minutes each):
Print in TPU, very slowly with cooling to allow each layer to cool, otherwise you'll end up with a misshapen blob.
Once you've filled the shaker, it should press in all the way to give a flat bottom. It gets stuck in really tight, so you may find it difficult to remove. Worst case, rip it out with pliers and pr
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA, TPU
Temps estimé
3 h
Post-traitement
Ponçage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection