Samsung Remote Control holder (Remix)
von Gertsen
50
Downloads
40
Likes
0
Makes
Remix of [SAMSUNG TV remote control holder] (https://www.thingiverse.com/thing:749450) by [Aragon](https://www.thingiverse.com/Aragon/about).
Changes:
I strengthened the lip holding the remote in place - just a little curve in the corner where it can't be seen anyway.
Then I removed the hexagonal holes in the main body of the holder.
I didn't really like the look of them, and I feel they weaken the holder.
They're not perfectly removed, since I made the change in [TinkerCAD](https://www.tinkercad.com/), and even though the part covering up the holes is a cropped copy of original body, it doesn't line up perfectly.
Ah well. But to me it wasn't really all that important. You have to look rather closely to even see it, and if you do see it, it's just part of the design, I guess.
Again: Not important to me, might be to you, in which case just ignore this remix :-)
Changes:
I strengthened the lip holding the remote in place - just a little curve in the corner where it can't be seen anyway.
Then I removed the hexagonal holes in the main body of the holder.
I didn't really like the look of them, and I feel they weaken the holder.
They're not perfectly removed, since I made the change in [TinkerCAD](https://www.tinkercad.com/), and even though the part covering up the holes is a cropped copy of original body, it doesn't line up perfectly.
Ah well. But to me it wasn't really all that important. You have to look rather closely to even see it, and if you do see it, it's just part of the design, I guess.
Again: Not important to me, might be to you, in which case just ignore this remix :-)
Gertsen veröffentlicht auch auf
25 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
