Thingiverse
Sand Casting Tools
por MiltonicPlague
49
Descargas
27
Likes
0
Makes
I took the extended tapered Sprue that Pauls Garage made and split it in half and made a pin for it in case you want to cast it.
I also recreated a surge trap and and riser that I saw on Swdweebs youtube channel. The Sprue should theoretically fit in a small hole on the surge trap.
I will also probably make some simple gates and if they work I might put them on here.
I uploaded the Sprue as one whole part instead of two halves because the two sides are not exactly the same size.
I also recreated a surge trap and and riser that I saw on Swdweebs youtube channel. The Sprue should theoretically fit in a small hole on the surge trap.
I will also probably make some simple gates and if they work I might put them on here.
I uploaded the Sprue as one whole part instead of two halves because the two sides are not exactly the same size.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
