Thingiverse
Sand Spike Basket
door B-Cup
8
Downloads
8
Likes
0
Makes
It's fishing time!
Here are a few different basket designs for mounting to a sand spike / fishing pole holder. I made the bottom mesh to allow water and sand to get out. Now get out and fish!
I included a thin model for the curved one with the divider for fast printing. I printed it with a .6mm nozzle at .3 layer height. Takes less than 3 hours. I do not think PLA would hold up, but PETG feels like a thick Pepsi bottle and is very flexible.
Another update:
I added a curved one for 2" OD PVC in case you are using home made spikes. I have not tried it since all of mine were purchased and have an outside diameter of 48mm. I was assuming on the 2" one that the outer diameter is actually 2". Good luck!
I also included the solidworks file for one of them so you can edit it any way you want.
Here are a few different basket designs for mounting to a sand spike / fishing pole holder. I made the bottom mesh to allow water and sand to get out. Now get out and fish!
I included a thin model for the curved one with the divider for fast printing. I printed it with a .6mm nozzle at .3 layer height. Takes less than 3 hours. I do not think PLA would hold up, but PETG feels like a thick Pepsi bottle and is very flexible.
Another update:
I added a curved one for 2" OD PVC in case you are using home made spikes. I have not tried it since all of mine were purchased and have an outside diameter of 48mm. I was assuming on the 2" one that the outer diameter is actually 2". Good luck!
I also included the solidworks file for one of them so you can edit it any way you want.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!