Thingiverse
sanding block
por miniskipper
190
Descargas
125
Likes
0
Makes
simple sanding block
Needs 2x M4 nut, M4 threaded rod ~32mm and optionally a washer.
Recommend 2mm thick rubber, strong foam or felt on the outside (160x35mm).
One of the nuts should be inserted in the knob: pause at the appropriate layer and put the nut in, continue print.
Other nut must be pressed into the slot of the body.
I cut my sanding paper 35 x 200mm.
Needs 2x M4 nut, M4 threaded rod ~32mm and optionally a washer.
Recommend 2mm thick rubber, strong foam or felt on the outside (160x35mm).
One of the nuts should be inserted in the knob: pause at the appropriate layer and put the nut in, continue print.
Other nut must be pressed into the slot of the body.
I cut my sanding paper 35 x 200mm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!