Thingiverse
Sanding Discs Holder
par joostan
54
Téléchargements
65
Likes
0
Makes
Thought I would share my latest design. Sanding Discs holder.
This has 12 compartments and designed for 125mm discs but can fit bigger ones too.
Designed in Fusion 360 and cut out on a xTool D1 Pro 20W
Instructions:
Single cut for the Back, Base and Front
Cut 13 Side and then just glue them into place.
I found glue the sides to the back panel first ignoring either end, then glue the base on then the front. Finally glue both sides on.
This has 12 compartments and designed for 125mm discs but can fit bigger ones too.
Designed in Fusion 360 and cut out on a xTool D1 Pro 20W
Instructions:
Single cut for the Back, Base and Front
Cut 13 Side and then just glue them into place.
I found glue the sides to the back panel first ignoring either end, then glue the base on then the front. Finally glue both sides on.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
