Thingiverse
Sandpaper Holder
10
Download
5
Likes
0
Makes
This is a block to hold sandpaper with a flat bottom. Since sandpaper pages are 9"x11" I sized it for a 2" x 9" strip of sandpaper.
Components:
1x base
1x wedge
2x knobs
You will also need two 1 inch 1/4-20 hex bolts and 2 1/4-20 hex nuts. I glued a strip of thin foam on the bottom to add a little bit of pliability to the sanding surface.
Components:
1x base
1x wedge
2x knobs
You will also need two 1 inch 1/4-20 hex bolts and 2 1/4-20 hex nuts. I glued a strip of thin foam on the bottom to add a little bit of pliability to the sanding surface.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
