Thingiverse
Sandwich Quad
por Zugara
13
Descargas
8
Likes
0
Makes
Ok so i thought i would have some fun and launch a 2 tier quad for the hell of it.
Running 8.5mm brushed motors
Beef's Brushed Board. BBB
1S lipo.
Camera mount for:-
http://www.banggood.com/Eachine-EF-01-AIO-5_8G-40CH-25MW-VTX-800TVL-13-Cmos-FPV-Camera-p-1064301.html
Without the case!!!
Flies really well and its a funky design.
You will need to wrap an elastic band around one of the top cut outs and then cable tie the other end together after wrapping the elastic band around the adjacent cut outs.
Lipo hangs underneath.
Receiver mounted onto of the FC.
You will need
1 elastic band
4 nylon standoff's M3
8 nylon screws approx 5mm long
1 BBB
1 micro receiver
4, 8.5 mm brushed motors
4 props to suit motor shaft
1 camera with the protective case removed
Double sided tape to secure the FC onto the frame
Running 8.5mm brushed motors
Beef's Brushed Board. BBB
1S lipo.
Camera mount for:-
http://www.banggood.com/Eachine-EF-01-AIO-5_8G-40CH-25MW-VTX-800TVL-13-Cmos-FPV-Camera-p-1064301.html
Without the case!!!
Flies really well and its a funky design.
You will need to wrap an elastic band around one of the top cut outs and then cable tie the other end together after wrapping the elastic band around the adjacent cut outs.
Lipo hangs underneath.
Receiver mounted onto of the FC.
You will need
1 elastic band
4 nylon standoff's M3
8 nylon screws approx 5mm long
1 BBB
1 micro receiver
4, 8.5 mm brushed motors
4 props to suit motor shaft
1 camera with the protective case removed
Double sided tape to secure the FC onto the frame
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
