Thingiverse
Sannce ip camera extension arm
by feletoch
1
Downloads
4
Likes
0
Makes
This is an extension arm mount for sannce i21ap ip camera on my tevo tarantula.
The arm is about 14cm long with 145 degrees bend. It should fit any 2020 v-slot rail.
The distance between 2 holes is about 27.5mm
Require
1x 8mm M4
1x T-nut
2x 8mm or longer M3
Note: v1.1 printed with PLA bends and snapped at the curve in hot area (summer). v1.2 add extra supports in the groves increase the strength of the structure.
The arm is about 14cm long with 145 degrees bend. It should fit any 2020 v-slot rail.
The distance between 2 holes is about 27.5mm
Require
1x 8mm M4
1x T-nut
2x 8mm or longer M3
Note: v1.1 printed with PLA bends and snapped at the curve in hot area (summer). v1.2 add extra supports in the groves increase the strength of the structure.
feletoch also publishes on
33 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!