Santa Bookmark, Hueforge

You do not need an AMS to change colours. At the layer where you should change colour, change to pause and manually change the colour when the print pauses. Project: Santa 2 x 6.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 50.64x152.46mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 1.4mm and the Actual Depth is 1.4mmFilaments Used: I do not know the transmission distances. PLA Generic Black PLA R3D Red PLA Polylite Cream PLA Generic White This print uses 4 unique filaments Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Red At layer #12 (1.04mm) swap to Cream At layer #13 (1.12mm) swap to White Boost Me