Thingiverse
Sapphire Pro/Plus Hemera mount
von mordant80
104
Downloads
69
Likes
1
Makes
This has now been tested by me printed in resin. Very solid mount.
I recommend 6mm m3 screws to mount the parts to the Hemera, stock Hemera screws will be too long.
It is for the newer style Sapphire with 3 holes.
This is designed so the filament path lines up with the existing hole on the stock bracket.
If mounted correctly your hotend will clear the z axis lead screw.
The fan duct position has been water tested and lines up where it needs to be. photo attached.
The part with the slot may require you to sand the bottom of the stock mount it attaches to to get the screw holes to line up. There is no tolerance where it butts up against the bottom to help keep everything solid
I have also included the .step files if you wish to remix
Note: 50x50x15 blower fan for part cooler is what this is designed for.
I recommend 6mm m3 screws to mount the parts to the Hemera, stock Hemera screws will be too long.
It is for the newer style Sapphire with 3 holes.
This is designed so the filament path lines up with the existing hole on the stock bracket.
If mounted correctly your hotend will clear the z axis lead screw.
The fan duct position has been water tested and lines up where it needs to be. photo attached.
The part with the slot may require you to sand the bottom of the stock mount it attaches to to get the screw holes to line up. There is no tolerance where it butts up against the bottom to help keep everything solid
I have also included the .step files if you wish to remix
Note: 50x50x15 blower fan for part cooler is what this is designed for.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
