Thingiverse
Sarrus Linkage Mark III
por fdavies
92
Descargas
247
Likes
1
Makes
This is the next step in my attempt to make a Sarrus linkage based 3D printer. The idea is to have a cartesian mechanism without those long rods and bearings.
I built three of the Mark III and mounted them in a x-y arrangement as shown. They can move over a square about 105 mm wide, and someday may carry an extruder. They are driven by DC motors taken from inkjet printers. These motors are driven in a servo arrangement using quadrature optical encoders and optical strips removed from the same printers.
I built three of the Mark III and mounted them in a x-y arrangement as shown. They can move over a square about 105 mm wide, and someday may carry an extruder. They are driven by DC motors taken from inkjet printers. These motors are driven in a servo arrangement using quadrature optical encoders and optical strips removed from the same printers.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
