SAS Fighting Knife Sheath

I really liked the print from this user https://makerworld.com/en/models/243438#profileId-890859 , but was thinking that the blade portion was quite fragile and could break if accidentally dropped, thus I decided to make a sheath for the knife :> The tolerances are a bit loose for the edge, but from the flat side it should sit nicely into the sheath, this is to prevent the wear of the prop edge. Roughly around 25g of filament used and print time is around 2h21m. If the blade is wobbly in the sheath, I recommend to carefully slot in some clear tape to make it more snug.