sc8luu

I present to your attention the composite model of the linear bearing cs8luu made with the use of BB 4.5 mm. This model can be made on any printer, even a beginner. For the primary assembly, you will need 120 BB4.5 ,screws M4x25 or more and 4 nuts for them.First you make the bottom and cover. after you put the balls in the guide groove, close them with a lid. This is necessary for more convenient assembly and adjustment of the bearing.when you have completely assembled the 2 halves, place the inserts between them and fasten them with m4 screws. This can be done both on the remote and on the installed shaft. If your bearing has a backlash, then you need to loosen the screws (it can be on one side) and remove the insert.It can be treated with sandpaper or simply replaced with a printed one with a smaller height (-0.1-0.2 mm). and collect again. Thus you can completely remove the backlash.Please note that the bearing should not move very tightly and be sure to use a lubricant.After we ha