Thingiverse
Scanning Crew Belt Boxes
door CraigPay
39
Downloads
39
Likes
0
Makes
This is simple design for a Scanning Crew belt box sized to match the 501st CRL guidelines:
https://databank.501st.com/databank/Costuming:IC_imperial_scanning_crew
"Dimensions are approximately 2 1/2" (63.5 mm) by 3 1/2" (88.9 mm) by 1" (25.4 mm) thick."
You normally print two boxes wearing one on either side of your belt.
The clip is optional. In the photos I've used a short length of leather instead of the clip fixed to the belt box with screws and washers.
If you get a smooth finish from your printing bed, print the 'box main' piece face down to reduce the need for sanding/filling before you paint.
Any questions, ask away!
https://databank.501st.com/databank/Costuming:IC_imperial_scanning_crew
"Dimensions are approximately 2 1/2" (63.5 mm) by 3 1/2" (88.9 mm) by 1" (25.4 mm) thick."
You normally print two boxes wearing one on either side of your belt.
The clip is optional. In the photos I've used a short length of leather instead of the clip fixed to the belt box with screws and washers.
If you get a smooth finish from your printing bed, print the 'box main' piece face down to reduce the need for sanding/filling before you paint.
Any questions, ask away!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
