Thingiverse
Sci-Fi Knife
door Raptr117
3
Downloads
2
Likes
0
Makes
Knife I designed myself, picture is of the cut in half version, the cut in half version is much thicker than the one piece version (knifeboi.stl). The knife in the picture is scaled up 230%, which was as large as my printer would allow with my bed. The two sides make it much sturdier and a little easier to grab as well, so I recommend thickening the one part knife to about 22mm if you upsize it.
Raptr117 publiceert ook op
18 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
