Thingiverse
scissors wallmount stand ножничный кронштейн
von sashasaf
16
Downloads
15
Likes
0
Makes
You get a rod diameter 10 mm and 135 mm long. Countersunk head screw; M3 x 8 mm x 2 and wide spacer M5 x 1. 1 round magnets diameter 12 mm and thickness 4 mm with hole diameter 4mm for screw M3. One magnet. One iron plate 40x40 mm and some 3M adhesive tape.
More strong thing like this you can see here: https://www.thingiverse.com/thing:4172766
scissors_hole_3.STL & scissors_thread_3.STL = pair. Each pair can give 70-80 mm of distance at normal use and up to 95 mm of distance at extremal traction. At traction more than 80 mm it slightly bends to the side under the weight of the device.
Print a nut for each printed thread.
wallmount.STL & cap.STL X 2 - one cap for each wallmount.STL
scissors_thread_2.STL X 1 & nut.STL X 2
slider_hole.STL X 1
slider_thread.STL & nut.STL X 1
magnet_stand.STL X 1
Scissors_hole_end.STL X 1
scissors_hole_3.STL & scissors_thread_3.STL = pair X as many as you want & nut.STL X 3 for each pair
Вам понадобится стержень или трубка диаметром 10 мм
More strong thing like this you can see here: https://www.thingiverse.com/thing:4172766
scissors_hole_3.STL & scissors_thread_3.STL = pair. Each pair can give 70-80 mm of distance at normal use and up to 95 mm of distance at extremal traction. At traction more than 80 mm it slightly bends to the side under the weight of the device.
Print a nut for each printed thread.
wallmount.STL & cap.STL X 2 - one cap for each wallmount.STL
scissors_thread_2.STL X 1 & nut.STL X 2
slider_hole.STL X 1
slider_thread.STL & nut.STL X 1
magnet_stand.STL X 1
Scissors_hole_end.STL X 1
scissors_hole_3.STL & scissors_thread_3.STL = pair X as many as you want & nut.STL X 3 for each pair
Вам понадобится стержень или трубка диаметром 10 мм
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
