Scope Parallax / Turret pointer - fixed and adjustable - 25mm, 30mm and 34mm

A range of fixed and adjustable scope parallax / turret pointers to suit 25mm, 30mm and 34mm scope tube diameters. Should be printed in flexible material, ideally PETG. PLA will work, but will break if stretched over the scope too often. Support not really needed, but if used can make the underside a little neater. I'd suggest using PLA as support for PETG prints, or Bambu support. I've included the correct support settings for PLA to support PETG in the print profile Other items needed:M3 x 12 bolt to fasten the pointer on the scopeM3 lock nut - note the model is designed to hold the nut captive, so the nut needs a firm push to fit0.8mm thick pin. I use stainless steel remote control model rods, or you could just use a paper clip For the adjustable pointers you'll also need:M3 x 18 bolt to fasten the adjustable sectionM3 lock nut The 0.8mm pin is a fiction fit, just hold it in vice / pair of pliers and push. Be careful, don't put your finger / thumb on the inside of the pointer ring,