Thingiverse
scratch pen holder
von CommanderGir
6
Downloads
12
Likes
0
Makes
Ball bearing supported pen holder to scratch pcb.
The Idea is to scratch a layout on a coated pcb and etch afterwards.
It is described by some other guy already
http://reprap.org/wiki/Scratch_n%27_Etch_PCBs.
I have printed it but not jet tried to use it. Since the print was disrupted the tube in the image is a bit shorter and the Plate on the end is not perfect aligned.
The Idea is to scratch a layout on a coated pcb and etch afterwards.
It is described by some other guy already
http://reprap.org/wiki/Scratch_n%27_Etch_PCBs.
I have printed it but not jet tried to use it. Since the print was disrupted the tube in the image is a bit shorter and the Plate on the end is not perfect aligned.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
