Thingiverse
Screenholder for Arcdroid with lid.
von Jarhan
1
Downloads
1
Likes
0
Makes
The screen has a tight pressfit.
I Drilled a hole behind the screen on left and right side so you can push the screen back out of the box if you need to.
Drill holes that fit your screenholder.
I used 15% innfill. Its a little bit soft, so you may go up a bit. But no problem like it is.
I Drilled a hole behind the screen on left and right side so you can push the screen back out of the box if you need to.
Drill holes that fit your screenholder.
I used 15% innfill. Its a little bit soft, so you may go up a bit. But no problem like it is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
