Thingiverse
Screw Box - Vase Mode!
von mitpro
15
Downloads
20
Likes
1
Makes
i really like the design of billioncash. And I learned a lot about the vase-mode. The result is this screwbox!
Advantages of using vase mode is a reduced printing time and reduced filament amount. With 0.8 nozzle, 0.45 layer heigth my printer only need 5 minutes an 4 g of filament! Great!!
It's designed for my volcano hotend 0.8 mm nozzle and a size of 60mm. Changing the Size and using an other nozzle should be no problem.
Vase Mode Required! 1 Outline, 1-2 Bottom Layer, 0 Top Layer.
Advantages of using vase mode is a reduced printing time and reduced filament amount. With 0.8 nozzle, 0.45 layer heigth my printer only need 5 minutes an 4 g of filament! Great!!
It's designed for my volcano hotend 0.8 mm nozzle and a size of 60mm. Changing the Size and using an other nozzle should be no problem.
Vase Mode Required! 1 Outline, 1-2 Bottom Layer, 0 Top Layer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
