MakerWorld
Other Tools
Go to Model
Screw down water bottle holder
32
Downloads
11
Likes
25
Makes
Water bottle holder that can be adapted to where ever you can bolt down the holder.Sized for Nalgene/Hydro Flask 1L bottlesFeatures cutouts on the side to get your hands on the bottle. High walls so that it will not fall out on vehicles like a tractor or 4-wheeler or side by sidedrain holes so that water will not pool on the bottombolt hole through the center with room for a washer if neededPrint in photos is with Bambu PETG HF. So far has been outside for about 6 months in 100F+ (probably much higher on the metal tractor) Arkansas summer heat and humidity. Has held up well so far.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
