Thingiverse
Screw Driver
von rfander
1
Downloads
2
Likes
0
Makes
This is a basic screw driver that holds standard sized hex bits. I made this to go with a gag gift for Christmas, but it turns out it is sturdy enough for light duty work as well!
Assembly:
The shaft and handle are two separate pieces. I designed it this way for ease of printing. When ready to assemble, just put some super glue on the pieces before slotting together.
If you plan to use metal bits, I'd recommend 100% infill for the shaft and gluing a 6mm magnet into the hex hole to keep the bits secured. Works like a charm
NOTE: I designed this using INCHES as my unit of measurement. If you are using Cura as your slicer, you will need to uniformly scale this model @ 2540%
Assembly:
The shaft and handle are two separate pieces. I designed it this way for ease of printing. When ready to assemble, just put some super glue on the pieces before slotting together.
If you plan to use metal bits, I'd recommend 100% infill for the shaft and gluing a 6mm magnet into the hex hole to keep the bits secured. Works like a charm
NOTE: I designed this using INCHES as my unit of measurement. If you are using Cura as your slicer, you will need to uniformly scale this model @ 2540%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
