Thingiverse
Screw on Hanging Loops (using TULAS)
door Wim_V
4
Downloads
4
Likes
0
Makes
4th example with the use of TULAS.
The flexible loop connection is made with a few cm's of TPU filament.
For screws/bolts Ø3/M3 with sunken head.
For more info on TULAS, how to connect the filament and how to use it with your own models:
TULAS: the universal hanging/strapping system
Note: As a TPU filament I tested with Ninjatek Ninjaflex which has a hardness of 85A. If you use TPU with a higher hardness (e.g. 95A) you cannot pull such tight knots and the chambers for the knots are too small. So use TPU of 85 Shore or lower.
The flexible loop connection is made with a few cm's of TPU filament.
For screws/bolts Ø3/M3 with sunken head.
For more info on TULAS, how to connect the filament and how to use it with your own models:
TULAS: the universal hanging/strapping system
Note: As a TPU filament I tested with Ninjatek Ninjaflex which has a hardness of 85A. If you use TPU with a higher hardness (e.g. 95A) you cannot pull such tight knots and the chambers for the knots are too small. So use TPU of 85 Shore or lower.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
