Screw Together Baseball Bat

-NOT MEANT TO BE USED IN ACTUAL BASEBALL- (You should be fine with plastic balls though). The bat is 2'4 long and the pieces are small enough for them to be printable on just about anything (Each piece is about 150cm tall) . The assembly is pretty simple -you just screw the parts together- and the bat itself is decently strong. You could get away with printing most of the parts at 3% adaptive cubic but I recommend increasing the infill around the protruding threads. Depending on how good your printer deals with overhangs, you only need supports on the top piece but it might be good to put it on the bottom as well. Make sure there aren't any supports on the threads though, or it will be a pain to remove This was reposted from my printables page, which is here https://www.printables.com/model/1645666-screw-together-baseball-bat