Thingiverse
Screw top container MKII
von HeyZeus
31
Downloads
16
Likes
0
Makes
A single thread version of a screw top container.
I printed mine with GizmoDorks Conductive ABS which is why the fill is at 40%. It doesn't seem to like to bridge over open fill structures.
Size: 2.67" Inside Diameter x 2.4" Depth
Printed without supports and fit together right off the bed.
2 lid files. one is for my intended use as a sharps container which has a small hole in it.
The other is solid.
The base has a slightly smaller OD. Might add to the customizer in the future.
Note: Originally uploaded files that were not scaled properly. If the object is too large. just scale to 0.254 to reach original intended size.
Uploaded correctly scaled files.
I printed mine with GizmoDorks Conductive ABS which is why the fill is at 40%. It doesn't seem to like to bridge over open fill structures.
Size: 2.67" Inside Diameter x 2.4" Depth
Printed without supports and fit together right off the bed.
2 lid files. one is for my intended use as a sharps container which has a small hole in it.
The other is solid.
The base has a slightly smaller OD. Might add to the customizer in the future.
Note: Originally uploaded files that were not scaled properly. If the object is too large. just scale to 0.254 to reach original intended size.
Uploaded correctly scaled files.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
