Thingiverse
Screwable Tolerance Test
von tomdavid
2
Downloads
1
Likes
0
Makes
this is light and simple tolerance test:
simply screw the both piece together, count the number of thread left and with
(number_of_thread_left + 1) * (ToleranceStep (default = 0.2mm))
get the tolerance of your printer
properties:
the thread are simply a circle extruded along a spiral
contains 5 screw thread the bottom one start with a diameter of (10mm + ToleranceStep), then (10 + ToleranceStep*2) + ... +up to (10 + ToleranceStep*5)
the model is fully parametric, using freecad you can set the ToleranceStep easily in the spreadshit
simply screw the both piece together, count the number of thread left and with
(number_of_thread_left + 1) * (ToleranceStep (default = 0.2mm))
get the tolerance of your printer
properties:
the thread are simply a circle extruded along a spiral
contains 5 screw thread the bottom one start with a diameter of (10mm + ToleranceStep), then (10 + ToleranceStep*2) + ... +up to (10 + ToleranceStep*5)
the model is fully parametric, using freecad you can set the ToleranceStep easily in the spreadshit
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
