Thingiverse
screwdriver holder (small and large)
door johnroy22222
20
Downloads
16
Likes
0
Makes
The large screwdriver holder is still a work in progress. the less than 1mm border is too thin. Plus you might consider increasing the spacing allocated to each "large scewdriver" (25 mm currently; my large screwdriver dont sit this well...)
I ve printed the small one with support and the large one without. Without support works fine.
PLA.
0.4mm
10% infill
I ve printed the small one with support and the large one without. Without support works fine.
PLA.
0.4mm
10% infill
johnroy22222 publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
