Thingiverse
Screwdriver Tip Safety Plug/Protector
by ericjwli
0
Downloads
1
Likes
0
Makes
Safety plug/protector for screwdriver tips. Has a venting hole at the top so you can always pull it off.
Fits all 6mm diameter driver shafts. Easy to press on and pull off. Snug fit.
The plugs will protect the tips from getting damaged if you drop them or if you want to keep tools in your pockets and dont want holes in your clothes!
I keep this short screwdriver in my snowboarding jacket so I can adjust my binding setup on the fly while on the mountain!
For best protection, print in TPU! PLA should be fine too but may crack eventually
No supports needed!
Fits all 6mm diameter driver shafts. Easy to press on and pull off. Snug fit.
The plugs will protect the tips from getting damaged if you drop them or if you want to keep tools in your pockets and dont want holes in your clothes!
I keep this short screwdriver in my snowboarding jacket so I can adjust my binding setup on the fly while on the mountain!
For best protection, print in TPU! PLA should be fine too but may crack eventually
No supports needed!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
