Thingiverse
Screwing Coin Wallet
door octo
907
Downloads
846
Likes
9
Makes
Printed in PLA, se support angle to 75% so threads are printed without suport.
Coins with diameter up to 2,5cm (1 inch) fit.
No need to keep coins in a certain order.
0 Dump coins in tube.
1 Just keep it at angle and shake the coins into a reasonable stack.
2 Now screw the top in untill the coins are stuck.
3 The top can be protruding or held within the tube.
4 To use the $$$ just unscrew one turn and dump the coins in your palm.
5 GOTO 0
Coins with diameter up to 2,5cm (1 inch) fit.
No need to keep coins in a certain order.
0 Dump coins in tube.
1 Just keep it at angle and shake the coins into a reasonable stack.
2 Now screw the top in untill the coins are stuck.
3 The top can be protruding or held within the tube.
4 To use the $$$ just unscrew one turn and dump the coins in your palm.
5 GOTO 0
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
