Screwless Tablet Stand - WACKOM V2

A much needed revision of my tablet stand print. I wanted to see if I could remake it without the need for screws and printable fasteners (first time doing this).
#### Improvements
##### Bottom Piece
- The bottom pegs that the angle legs catch on have no more annoying rectangle pieces that separate the pegs. I couldn't tell if the legs caught onto a peg or one of the skinny beveled bits I should have removed in the first place. Now it is just the pegs and nothing else.
- The bottom pegs themselves are thinner.
- The bottom piece now has plastic indents you can feel for to know which peg you can slot the angle legs into.
- The bottom's tab that keeps the tablet in place and on the edge of your desk is thinner and flat instead of curved.

##### Angle Leg Piece
- The angle legs are now skinnier on the ends. I would have trouble with them falling on the pegs and it would just be too thick that it wouldn't fall into the pegs.
- The legs now have smaller catches for the pegs on the bottom p