Scrub Daddy Holder

My wife asked me to make a holder for the scrub daddy sponge and this is the result. It sits on the side of the sink with an outlet for the water It's simple print, I used PLA, 3 loops and 3 layer for base and top surfaces. It will print without support, although you could add support under arms. The legs print separately, the inner side each leg is flat to lay on the print bed. The legs slide and clip onto the main holder. this si not my orginals model. https://www.printables.com/model/1523974-scrub-daddy-holder GaryMo @GaryMo_770624 https://www.printables.com/@GaryMo_770624