Scrub Daddy Sponge Holder

Based on the design by TampaJoey but I changed it up a little and added a stand to prop the dish at an angle for better drainage and a mount for a suction cup to go to hold it in place.

The stand is designed to be held down to a smooth surface with a 40mm suction cup like with the other sponge holder I designed. The ones I used can be found at Amazon: https://www.amazon.com/dp/B0CJHXQ4NS?ref=ppx_yo2ov_dt_b_fed_asin_title

Prints in 3 parts. The tray and dish can both be printed without support. For the stand, I would recommend rotating it 90 deg to its side to make the print stronger where it bends so it's less likely to break. The stand WILL NEED support if you print it this way. Feel free to print without the stand if you'd like. Still works fine, but won't be held in place without the suction cup.