Thingiverse

Sculpfun S10 Limit Switch Mount

by R4iNER

4 Downloads

4 Likes

0 Makes

These are the end stop mounting brackets for the Sculpfun S10 laser. I moved the Y end stop to the right side to use shorter wires and have a neater install.
The models are suitable only for the switches from the last image, if the board has no electronic components populated on the PCB then you'll need to use only two wires (cut the V).

Additional hardware:
- at least 4x M3 18mm bolts&nuts for the covers
- 2x M5 bolts the top one is 14mm and the side one 8 mm
- Optional 2x wood screws M2.5 15.5mm

You'll need to print two case.obj, they are the same for both brackets.

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format