Thingiverse
Sculpfun S9 Alignment Camera Mount
door LHartmann
22
Downloads
13
Likes
0
Makes
Camera mount for adding a [USB endoscope](https://www.aliexpress.com/item/32255881055.html) as aligment camera to a Sculpfun S9.
This takes away about 10mm Y travel.
Installing:
- Install the camera on the clip.
- Use a flat surface and a reference edge to rotate the camera appropriately.
- Install the clip on the laser head.
The clip is designed to flex when installed on the head, gripping both the head and the camera in the process. Camera should be hard to turn after placed on the laser head.
Some photos are from a previous version, no front slot cut, and no flex-Iock. it was impossible to rotate the camera on that one.
This takes away about 10mm Y travel.
Installing:
- Install the camera on the clip.
- Use a flat surface and a reference edge to rotate the camera appropriately.
- Install the clip on the laser head.
The clip is designed to flex when installed on the head, gripping both the head and the camera in the process. Camera should be hard to turn after placed on the laser head.
Some photos are from a previous version, no front slot cut, and no flex-Iock. it was impossible to rotate the camera on that one.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
