Thingiverse
Sculpfun S9 Mounting feet
di Nunu57
39
Download
21
Likes
0
Makes
Mounting feet for Sculpfun S9.
It provides an additional screw to block the Laser Engraver on the feet.
Feet increase high of engraver of 20mm (size used by Ortur honeycomb support https://amz.run/5Ba5 )
Needed materials:
- 16 x : M4 nuts
- 4 x : M4 x 10mm screws (to block the laser engraver)
- 12 x : M4 x (10 + width of the support) mm screws (in my case 30mm)
It provides an additional screw to block the Laser Engraver on the feet.
Feet increase high of engraver of 20mm (size used by Ortur honeycomb support https://amz.run/5Ba5 )
Needed materials:
- 16 x : M4 nuts
- 4 x : M4 x 10mm screws (to block the laser engraver)
- 12 x : M4 x (10 + width of the support) mm screws (in my case 30mm)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
