Thingiverse
Sculpto handle roller
von moga
5
Downloads
2
Likes
0
Makes
### This project has been has been discontinued as I found that too often the spool would not roll as expected but in stead get stuck. In stead I designed something to hang on the back of the shelf I have above: https://www.tinkercad.com/things/8Qim0OXogrM?sharecode=c5w_8dJv8uNpeg41WsMEwVw5IvLs3VbjeYvqg6mRf-o
I originally made to 'ears' for my Sculpto Plus: https://www.thingiverse.com/thing:3183535 but when I received my Sculpto PRO 2 it was 4 cm taller and the spools would not fit between the handle and the shelf above.
Actually it would not even fit a full spool on top of the handle, so that made it a little challenging.
This 'handle roller' is put on top of the handle, to turn it into a filament spool holder.
The spool is turned as much as it is possible to still allow a (new as of end 2019) 500 g spool to be able to span the handle.
**WORK IN PROGRESS -> NOT WORKING**
A rod is put through a hole on each side. LEGO crossbars work great!
On the side closet to wh
I originally made to 'ears' for my Sculpto Plus: https://www.thingiverse.com/thing:3183535 but when I received my Sculpto PRO 2 it was 4 cm taller and the spools would not fit between the handle and the shelf above.
Actually it would not even fit a full spool on top of the handle, so that made it a little challenging.
This 'handle roller' is put on top of the handle, to turn it into a filament spool holder.
The spool is turned as much as it is possible to still allow a (new as of end 2019) 500 g spool to be able to span the handle.
**WORK IN PROGRESS -> NOT WORKING**
A rod is put through a hole on each side. LEGO crossbars work great!
On the side closet to wh
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
