Thingiverse
SD card adaptor Holder
door Webberen
7
Downloads
2
Likes
0
Makes
This works together with the microSD to SDcard -adaptor.
Tired of using the tiny microSD on your Wanhao i3 ???
Here is the (or one of) the solution(s) !
The Angled version is showed in pics. The "mount in 25mm hole" is not yet printed.
The idea is to use some doublesided tape to put it, either on the printer og extend the wires to make it fit where you would want it.
It should be printed slightly larger in scale, not much, just a bit...
Link to the adaptor from dealxtreme.com:
http://www.dx.com/p/sd-to-microsd-transflash-card-converter-module-27001#.Vl3miPkveUk
Follow me on YouTube #MakerSPACE #by #webberen - https://www.youtube.com/channel/UCvrmGlBdrKYqQ4iJ4Tx8Tqw
Tired of using the tiny microSD on your Wanhao i3 ???
Here is the (or one of) the solution(s) !
The Angled version is showed in pics. The "mount in 25mm hole" is not yet printed.
The idea is to use some doublesided tape to put it, either on the printer og extend the wires to make it fit where you would want it.
It should be printed slightly larger in scale, not much, just a bit...
Link to the adaptor from dealxtreme.com:
http://www.dx.com/p/sd-to-microsd-transflash-card-converter-module-27001#.Vl3miPkveUk
Follow me on YouTube #MakerSPACE #by #webberen - https://www.youtube.com/channel/UCvrmGlBdrKYqQ4iJ4Tx8Tqw
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!