SD Card Case

Case to store SD cards. This case is a friction fit design so no extra parts will be needed to hold the case shut. Just press it shut, and it will stay closed until you pull it apart again. It can fit 16 SD cards and once closed the SD cards will not move from the slots. Slots for the SD cards have enough clearance that they are not damaging the SD cards, but also not letting them rattle around too much. Depending on the tolerances of your specific printer, the z-seam may need to be sanded down or worked a little to get the friction fit rim to slide nicely. I have not had to sand any that I have printed, but some I did have to move the top on and off a couple times for them to slide nicely. If your clearance seems tight around where the z-seam is, I recommend trying this method before trying to sand the z-seam down. Dimensions are approximately: 65.6mm x 60.8mm x 38.3mm