Thingiverse
SD Card Case
by ImAThingsGuy
71
Downloads
56
Likes
1
Makes
I know it may not be the most ergonomic design but I was very happy with the result.
There is a bit of tolerance in each cell slot so that you can glue in a small piece of foam, this allows an SD card to have a kind of "soft pressure" hold that is a lot nicer than a lose fit or a fit that causes the SD and print to grind together.
There is a bit of tolerance in each cell slot so that you can glue in a small piece of foam, this allows an SD card to have a kind of "soft pressure" hold that is a lot nicer than a lose fit or a fit that causes the SD and print to grind together.
ImAThingsGuy also publishes on
17 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
