Thingiverse
SD Card Holder (9)
von Steve061
6
Downloads
8
Likes
0
Makes
Wanted to use less material, take up less space and have a lid so they didn't fall out. ie: it is a new design based on the original.
The walls are designed for a 0.4mm nozzle (ie multiples of 0.4) and the heights are designed for 0.2mm layers with a first layer of 0.24mm (I use to get a good stick)
The difference between the two bottom files is just V2 uses less material by scooping out the dividers.
The walls are designed for a 0.4mm nozzle (ie multiples of 0.4) and the heights are designed for 0.2mm layers with a first layer of 0.24mm (I use to get a good stick)
The difference between the two bottom files is just V2 uses less material by scooping out the dividers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
