Thingiverse
SD Card Holder
von Technalyzed
153
Downloads
93
Likes
3
Makes
12 Slot 6-SD Card / 6-Micro SD Card holder (55mm X 20mm X 10mm W/D/H)
The attached image was printed with PLA on a 40C bed, no supports, no raft, .2mm primary layer height, and 15% infill.
The SD card slots are recessed 9mm and the Micro SD card slots recessed 5mm.
The attached image was printed with PLA on a 40C bed, no supports, no raft, .2mm primary layer height, and 15% infill.
The SD card slots are recessed 9mm and the Micro SD card slots recessed 5mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
