sd card holder

this was designed to bolt to a 2020 rail using m4x10mm with m4 washers and t-nuts. The original design was messed up so i redesigned it this time with a window so you can see what card is in there. i am printing with eSun PLA+ at 235c with a dual 5015 fang fan setup. the bed is set at 65c until half the part is reached, then it drops to 50c to reduce the time required to remove the part from the heated bed. I also use hairspray to help adhere this part to the bed. i am printing 9 at a time, it fits my tevo bed pretty good.The file contains just one copy.

print with no supports. use parts cooling fan at maximum before you reach the layers at the top.