Thingiverse
SD Card Holder
door artwolf
6
Downloads
9
Likes
0
Makes
This should be able to go good slipping into a Tronxy X3a Printer.
The one thing is that you have to sand under the SD Card sits in the lip. sanding paper remove some plastic so the Little Piece fits snug into the SD Card slot. Just need to sand under the lip of SD Card and it should slip in and out of the SD Card Slot no problem.
The SD Card needs to be pushed in pretty good to fit inside the SD Lips holder
i use pliers to squeeze so the SD holds better
The one thing is that you have to sand under the SD Card sits in the lip. sanding paper remove some plastic so the Little Piece fits snug into the SD Card slot. Just need to sand under the lip of SD Card and it should slip in and out of the SD Card Slot no problem.
The SD Card needs to be pushed in pretty good to fit inside the SD Lips holder
i use pliers to squeeze so the SD holds better
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!