Thingiverse
SD Card Tray
por sroyalty
7
Descargas
5
Likes
0
Makes
Tray for storing SD Cards. There is a 10 card and 20 card model.
As with my NVME tray, recommend 100% infill and if you get artifacts in the slots just slow the speed or clean it out post print.
v3 - Same as v1 but 1mm less for width for a tighter fit on the cards
v4 - Same as v2 but 1mm less for width for a tighter fit on the cards
As with my NVME tray, recommend 100% infill and if you get artifacts in the slots just slow the speed or clean it out post print.
v3 - Same as v1 but 1mm less for width for a tighter fit on the cards
v4 - Same as v2 but 1mm less for width for a tighter fit on the cards
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
