Sealable Waterproof Cable Power box

I needed to dig some cables in the ground and had that allready before, but from time to time the boxes i bought got water inside and the result was that my fuse felt out.

So I designed this small box where you can solder your cable inside and take easy buyable 2k Epoxy to put it and screw the lid on, Waterproof and no issue anymore, the wholes on the side you can drill on the size you need.

I printed it 100% infill, you don't need any support.

2k Epoxy you get everywhere in every home depot shop.

it uses around 12.5 mg of it to fill completely, the screws are 2.5" x 12

There is as well a double sized one under the following Link, for that you need 25mg of Epoxy 2k to fill out.

The picture attached is the bigger one as the small one didn't fit my big cables, one side was a 5.5 mm cable and on the other side it was 7.5 mm. That size of cables need the bigger one...

http://www.thingiverse.com/thing:1585629