Slicer Discord
Seat belt plug angled – Modelo 3D imprimible de Thingiverse Thingiverse

Seat belt plug angled

por rofsdahl
22 Descargas
25 Likes
1 Makes
Ver Modelo
A minimalistic seat belt plug. This stops the seat belt alarm from going off when you lay the rear seats flat and put cargo on top. The plug is short enough to not leave dents in the backrest.

This is a remix of "Buckle Plug Keychain" by Cleven. The original design fitted perfectly in my Tesla Model Y, except that the plug would leave marks on the backrest when I laid it flat. I shortened the plug, and now it just barely snaps into place in the rear seat buckles. The plug does not fit in the front seats (the plug is too short).

Note! Don't drive without using a seat belt!
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección