Seat Post Lever

manetka_wakacje_v50.stl are the best part right now
but I replace a bike mounting screw for regular 5x16 screw
you also will nead ptfe tube, wich you can find inside bike cabel armor
for this body you also will nead waicha z wcienciem_.stl, cause it hawe mor space for the hing.



Due to the lack of a good design of such an element for 3D printing, I decided to take care of it myself.
I did it on Ender 3.
It is a seatpost shifter with a cable pull of just over 12mm. takes up 13 mm of the width of the handlebar. the transmission force of the pull on the lever is a maximum of 0.3, which makes the lever hard, which is intended to reduce the risk of accidental pressing during intense cycling.
It works, I used it in difficult conditions, I had accidents and everything still works.
In the photos you see the old version which was unergonomic.
post a make, if you do it, I will be very pleased
If you have any comments, pl