Thingiverse
Seckit Go Raspberry Pi Mount
von iplop
9
Downloads
4
Likes
0
Makes
I've abandoned Thingiverse due to them disabling downloads.
Because of Thingiverse's decision, the model you are looking for can no longer be found here on Thingiverse.
You can find this model at: https://www.prusaprinters.org/prints/134010-seckit-go-raspberry-pi-mount
This is a simple back plate raspberry pi mount for the Seckit-Go. It works for any raspberry pi case with mount screws at 68mm x 98mm. You can either press fit m3 nuts on the mount or screw in m3 bolts.
Because of Thingiverse's decision, the model you are looking for can no longer be found here on Thingiverse.
You can find this model at: https://www.prusaprinters.org/prints/134010-seckit-go-raspberry-pi-mount
This is a simple back plate raspberry pi mount for the Seckit-Go. It works for any raspberry pi case with mount screws at 68mm x 98mm. You can either press fit m3 nuts on the mount or screw in m3 bolts.
iplop veröffentlicht auch auf
58 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
